Hello,
I purchased ESPHome GU10 bulbs but wanted to switch to WLED to use ArtNet. I've read going to Tasmota lite ESP02 and then flashing to WLED would work but I have now the bulb stuck in blue and no wifi signal from it. I have tried to switch it on and off 5 times but no luck. For my ikea GU 10 I like Is there any video to help respecting the pace for the reset? Ikea has done one and it's useful:
1. How to properly migrate from ESPHome to WLED on the Athom GU10 bulbs? 2. How can I bring back to life my bricked bulb? Thank you.
And then I could flash the WLED firmware on it following:
UPDATE : ANSWER FROM ATHOM
First execute "SetOption78 1" in the console of Tasmota
Select firmware upgrade, upload tasmota-minimal.bin and click start upgrade
Select the firmware upgrade again, upload the firmware of WLED and click to start upgrade
https://drive.google.com/drive/folders/1oYbf1ueoONFacbG2FQ1cIxjWo47cy1U9?usp=sharing
Source: https://www.reddit.com/r/WLED/comments/pvtuvx/change_firmware_from_tasmota_to_wled_on_an_athom/ I used the firmware Athom_RGBCW.bin.gz