• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    この動作を確認するには、公開後のサイトへ移動してください。
    • カテゴリー
    • すべての記事
    • マイポスト
    gaucho
    1月24日

    Issues with UK PG04 Plug (pre-flashed Tasmota)

    カテゴリー: Plugs

    I just had 4 new pre-flashed plugs delivered from the Athom Aliexpress store. When I plug them in the Tasmota hotspot appears as expected, but every time I set the wifi information it reboots and connects the the AP but never becomes accessible. Specifically - the web interface never loads fully and the devices are not pingable. I can reset them (7 short power cycles) and get the setup AP up again... but then the same loop starts again.


    Am I doing something wrong?


    I have tried two different access points to make sure the problem isn't on that side. I have previously been using Gosund UP111 devices and flashing them myself with tuya-convert so I am not new to this... I just thought I'd try these pre-flashed devices to make things easier... but so far it hasn't worked out that way!


    Thanks for any ideas or guidance.

    0件のコメント
    0
    コメント

    ご意見をお寄せくださいコメントを残すにはサインアップしてください。

    0件のコメント
    同じような記事
    • Flash Homekit version switch with Tasmota?
    • Athom plug manual re-flash
    • Is it possible to flash plugs from Tuya to tasmota over the air by raspberry with hotspot?

    ©2020 by athom.