I flashed my newly arrived Athom Smart Plugs V2 (Swiss Plug) from Tasmota to ESPHome via the instructions given but forgot to set SetOption78 1 but was still able to flash ESP8266_MINI.bin. After that, i was able to connect to the plug using the IP-Adress given to it by the router. Then i created a conifg in ESPHome, downloaded the bin and flashed the same image onto all four plugs. (A mistake, i guess) The first one is working fine, the other three seem to connect to the wifi (as they are given an IP-Adress) but i can't connect to them in any way (IP Adress in chrome gives back 'Connection Refused', SSH or Telnet is also refused). How can i recover the plugs?
top of page
この動作を確認するには、公開後のサイトへ移動してください。
Smart Plug V2 connects to Wifi but is inaccessible
Smart Plug V2 connects to Wifi but is inaccessible
3件のコメント
いいね！
Comments（3）
この投稿へのコメントは利用できなくなりました。詳細はサイト所有者にお問い合わせください。
bottom of page
Dear Athom Support Any help would be appricieated. I can see that the Plugs are on my network since i can ping them, but i can't access the web interface. Is there any way to reset these plugs to factory default?