Looking to see if I'm doing something silly with my first venture into WLED
I have 2 separate short strips of WS2805 RGBW LEDs both using the same setup - They are set up using a 12v LED Driver and an Athom LS-4P.
One strips works well - No Issues at all
The second strip will only allow me to access the web interface if the LED strip is turned off - If the LED strip is on, I cannot load any of the web interface pages until I switch the LEDs off - I'm using the latest Beta (because WS2805)
The backup data line is tied to ground
I have switched off all the Sync stuff - This made no difference
I have replaced the problematic athom controller with a new one - It does the same
I have tried a static and a dynamic IP - Still unable to load the UI
Does anybody have any other suggestions??